Community > Discussion Forum > Error code 999

Discussion Forum

Error code 999

Topics: Mesh, 4.2a

Thread index  |  Previous thread  |  Next thread  |  Start a new discussion

RSS FeedRSS feed   |   Email notificationsTurn on email notifications   |   1 Reply   Last post: January 24, 2012 7:00am UTC
Mohamed Elgabaili

Mohamed Elgabaili

January 24, 2012 3:17am UTC

Error code 999

Hi
I am trying to mesh my geometry which is a round parachute canpoy , but everytime an error code number 999 appears and the meshing dosnt go through, the type of mesh I am useing is free tetrahedral. Please I need ur suggestion on this matter.
Best regards

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse

0 votes
Ivar Kjelberg

Ivar Kjelberg
Moderator

January 24, 2012 7:00am UTC in response to Mohamed Elgabaili

Re: Error code 999

Hi

meshing is an art, one gain the knowledge how to, by meshing, so be patient.

Try to cut your domain into several smaller ones i.e. 2,3,4 domains and mesh them independently. You add a few "internal" boundaries but often the meshing is simpler

--
Good luck
Ivar

Reply  |  Reply with Quote  |  Send private message  |  Report Abuse


Rules and guidelines